3mirrors LS Engine Flywheel Holding Locking Tool Kit For 4.8 5.3 5.7 6.0 6.2 LS1 LS2 LS3 LS6 Chevy LSX Camaro, Corvette, Trans am, GTO, G8, CTS V, GM Trucks
16 Reviews
In Stock
- This Engine Flywheel Locking Tool kit is compatible with all LS engines (all GM gen III, IV, and V engines).
- 100% brand new, precisely manufactured from high-quality materials with Zinc coating to prevent the fitting from being rusty, durable, and long service time
- You just need to put the bolts in the corresponding holes and tighten them, only takes a few minutes
- It comes with one holding tool starter and two bolts (FD 8.8, Pretty Tough & New Design), Better than others
- A good handy tool can help you save time and money.
Great tool
Worked perfect, did the job.
Dan Cashon March 31, 2018
Great
Great Product
Eric Kirtson May 21, 2020
5.3l flywheel holding tool
Works perfect
Patrick Reynoldson May 16, 2021
Satisfied
Made job easy
David Isbellon May 26, 2021
Would recommend and buy again
I couldnt imagine trying to torque a harmonic balancer without it. This is great tool
Jackon May 27, 2021
Time saver
If you replacing your harmonic balancer this is a most have tool. Jamming screw drivers or brybars in to the flex is not worth the frustration. Buy the tool.
HotRodon June 7, 2021
AVOID DO NOT BUY
Came in rusted with dirty welds. Not even engaging half of the teeth surface.
Luon July 31, 2021
Did the job as advertised.
Used this on an ls3 to install flywheel and clutch as well as the crank pulley bolt. The teeth meshed up perfectly with the flywheel and did the job.
Anonymouson August 7, 2021
Flexplate holder
Does its job, motor doesnt rotate.
Tiggerzon August 9, 2021
Gnarly Rust Spot
Arrived with a gnarly rust spot. My dad was surprised that the manufacturer shipped out this, since he wanted the zinc coating for the purpose of it being rust resistent. We live in Alaska so its not worth the hassle asking/waiting for a replacement. Probably wont order from these guys again.
Jeanneon September 15, 2021
Dont waste your money!
This tool didnt ven come close to lining up with the starter bolt holes. I had to cut it apart and reweld it to make it work and still it doesnt fully engage the ring gear. I would actually have to add material for that. And if you think rewelding it isnt a big deal think again! This metal is not a carbon steel piece. It may have some steel in it but theres and alloy of some sort that does not like to weld at all. Im sure it welds fine if you have the proper equipment but a mig process doesnt work great. I had to pile on the wire to make it strong enough. Buy a name brand to avoid this issue.
Martyon March 12, 2022
It did work
Item did work but barely lined up on teeth of flywheel for me to hold it.
Dave Hon March 29, 2022
Quality tool fit perfect
Worked great
colsonon April 11, 2022
Great
Could not have done my work without it.
Jesse Umbreiton April 14, 2022
Rust
Product worked great and torqued to 200lb so definitely very sturdy. Did have rust like the other photos on here.
Tyler J. Dietzenbachon May 9, 2022
Works well
Works well
Omar Gallardoon October 16, 2022